Owner's Manual

29
EN
Quick reference
OPERATION MESSAGES
MESSAGE LANDROID VISION ACTION
Cutting grass Cutting grass according to the mowing schedule.
Raining
The rain sensor detects water. Landroid Vision will return to the charging base and stay
there for the time you have programmed it to do so. When dry, Landroid Vision will auto-
matically begin the rain delay countdown and then return to mow. If you want Landroid
Vision to mow before this, simply turn it off then on again, but only when the rain sensor is
dry, or you can remove the rain delay completely by setting the rain delay time to zero.
Going home Needs to recharge—during the journey to the base, the cutting blade is stopped in order
to save energy.
Charging ‘Charging’ and charge percentage are displayed.
No working time scheduled Stand-by, needs to be programmed as desired.
Not working today
Stand-by, will start according to mowing schedule.
Work done today
Zone searching
According to the setting of “Customize work zone”, Landroid Vision is searching a certain
area to mow.
Charge complete Landroid Vision has completed its charging.
Emergency charge Landroid Vision is charging in a powered-off state.
ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid Vision is smart enough to tell you if it is enountering an issue, so you can fix
it. If in doubt, please visit our website where you will find useful videos and further support.
MESSAGE CAUSE ACTION
Battery pack cover is open. Close the battery pack cover.
Outside working
area! Press START to
reset.
Landroid Vision cannot find
the lawn border.
1. If Landroid Vision is actually outside of its working area: turn power
off, take Landroid Vision inside the working area, turn the power on and
press start.
2. If Landroid Vision is inside its working area check if the LED on the
charging pile is solid green.
WRONG PIN! Please
retry.
PIN code is wrong. Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to
reset.
Blade disc is blocked by an
object, e.g. a branch.
Turn power off.
Turn Landroid Vision upside down and check if there’s anything preven-
ting the blade disc from rotating and remove any obstruction.
Turn Landroid Vision upright.
Turn power on. Press start.
Blade is over-loaded by thick
dense grass.
Turn power off.
Take Landroid Vision to an area with short grass or adjust the cutting
height to a higher setting.
Turn power on. Press start.