Owner's Manual

30
EN
Quick reference
MESSAGE CAUSE ACTION
Wheels motor fault!
Press START to
reset.
Wheel motor is blocked in
some way.
Turn power off and take Landroid Vision to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
Vision upside-down and check if there’s anything preventing the wheels
from rotating.
Remove any obstruction, turn Landroid Vision upright, turn power on.
Upside down! Press
START to reset.
This could have happened
when Landroid Vision came
into contact with a sloping
surface which made it over-
turn.
Turn Landroid Vision upright and remove any obstacle that might have
caused Landroid Vision to overturn.
Mower trapped!
Press START to
reset.
Landroid Vision is trapped.
Turn power off.
Take Landroid Vision to an area of your lawn free of obstacles, then turn
power on. Press start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid Vision upright, turn power
on.
Mower lifted! Press
START to reset.
Landroid Vision has been
lifted up.
Turn power off.
Take Landroid Vision to an area clear of obstacles, turn power on. Press
start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down and check there’s anything that can cause Landroid Vision
to be lifted up.
Remove any possible object, turn Landroid Vision upright, turn power
on.
Battery voltage too
low! Please change
battery.
Battery exausted, and needs
to be recharged.
In this case you must turn Landroid Vision off and place it in the charging
base, then ‘Emergency charging’ will be displayed and it will start
charging. If the battery error still persist, your battery is damaged and
need to be changed.
Battery temperature
out of range!
Please wait.
Temperature is too high (more
than 55
0
C) or too low(less
than 3
0
C) when charging.
Place the charging base in a shady area or wait until it reaches the nor-
mal temperature.
Can’t find charge
station press START
to reset.
Machine doesn’t have
enough power to go back to
charging base.
Take Landroid Vision to the charging base.
Mower locked!
With the “Lock Function”
enabled, if your Landroid
Vision does not receive a
signal from your Wi-Fi router
for 3 days, then it gets locked
as a security measure.
This could be because
your router lost its power
or because you changed
your Wi-Fi router or network
provider.
Please reconnect Landroid Vision to the Wi-Fi networtk it has been origi-
nally paired with. If this is not possible, contact Cutomer Service.
RFID not found!
RFID is not installed correctly. Check if RFID is correctly installed.
RFID signal is weak. Install the RFID with same number beside the original one.
Camera fault!
Camera covered by dirty
things.
Clean the camera.