Owner's Manual
31
EN
Quick reference
NOTES
A. Before turning power on, always check Landroid Vision is inside its working area. If not, the message “Outside working area!
Press START to reset” will be displayed. This message is also displayed when Landroid Vision is partly but not completely inside its
working area.
B. If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging base: press home then
. Landroid Vision will go to its base and stay there. Please note Landroid Vision will now wait until the next scheduled mowing
session. If you want to re-start it at anytime, press then to start your Landroid Vision.
C. If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer to
the installation instructions and check your set up is correct with its help.
D. If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging base: when Landroid Vision runs out of charge, take it manually to the charging base.
E. If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then
restart it. If the problem cannot be solved, please contact our Customer Service for help.
7. TROUBLESHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM CAUSE SOLUTION
The LED light on the charging
pile does not turn on.
There is no power.
Check the charging base is connected properly to the charger
and the charger is connected to a suitable power supply.
Landroid Vision turns on,
but the blade disc does
not spin.
Landroid Vision is searching for
the charging base.
This is normal: when Landroid Vision needs to recharge, the blade
disc does not rotate while it is searching for the charging base
automatically.
Landroid Vision vibrates.
The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
Grass is being cut
unevenly.
Landroid Vision does not work
enough hours per day to cut the
grass.
Try adding more hours to the mowing schedule.
Mowing area is too big for the
size of Landroid Vision you have.
Try decreasing the size of the mowing area or increasing working
time.
The blades are dull and not sharp.
Change all the blades and screws in order to balance the bade disc.
The cutting height is set too low
for the length of the grass.
Raise the cutting height and then gradually lower.
Grass or another object has
wrapped around the blade disc.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
There is a build-up of grass in the
blade disc or motor frame box.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Recognition error
Remove the obstacles, such as leaves.
The secondary area is
not mowed.
Programming error Make sure the RFIDs are installed correcly and reprogrammed.
There are obsacles between the
RFIDs in the pathway.
Remove the obstacles.
The charging time is
far more than the rated
charging time.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
The charging protection
program is activated due to high
temperature.
Place the charging base in a shady area or wait until the
temperature has cooled down.