Owner's Manual

32
EN
Quick reference
SYMPTOM CAUSE SOLUTION
The mower does not
charge.
There is no power.
Check the power cord is connected properly to the charger and
the charger is connected to a suitable power supply.
Make sure both the charging strips on the mower touch the
center of the charging contacts on the charging pile.
Landroid Vision is starting
to have shorter run-times
between charges.
Something is clogging in the
blade disc creating friction and
increasing power consumption.
Take off the blade disc and clean it. Maybe the grass is too high
and too thick.
Landroid Vision is shaking heavily
because the blade disc is unba-
lanced.
Check the blade disc and blades, remove debris and foreign
objects from the blades and blade disc.
Replace the blades with a new set.
The battery may be exhausted
or old.
Replace battery.
The working time is up. Reset the working time.
Landroid Vision is not
operating at the correct
time.
The clock is not set to the cor-
rect time.
Set the clock to the correct time.
Programmed cutting times for
Landroid Vision are not correct.
Change the time settings for the mower to start and stop.
The percentage of weekly ope-
rating time set through APP has
changed.
Set the correct percentage through APP.
Landroid Vision can not
find the charging base.
The direction of the charging
base is incorrect.
Make sure Landroid Vision dock right towards the charging base
and departures in anti-clockwise direction.
There are obsacles in front of the
charging base.
Please remove the obstacles within the 2m in front of the char-
ging base.
Landroid Vision cannot
correctly dock with the
charging pile.
Environmental influences. Restart Landroid Vision.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
The QR code is sheltered.
Make sure the QR code is clear and that there is nothing directly
on it or above it.
The green light on the
charging pile turns
on before charging is
complete.
The charging base is overheating
or overcooling.
Place the charging base in a shady area or wait until it reaches
the normal temperature.
Landroid Vision wheels
skid or repeatedly slip.
Obstacles, such as twigs and
branches may be lodged under
Landroid Vision.
Remove objects from underside of Landroid Vision.
The lawn is too wet.
Exclude the wet or soft ground areas by using the magnetic strip
or by creating a non-grass pathway that is more than 50mm
wide until the lawn is dry again.
Landroid Vision
slips out
of its working area.
Low grip of Landroid Vision drive
wheels.
Please check the wheels are clean and free of mud in order to
have the maximum grip possible.
The slope is steeper than
30%(17
o
).
Exclude the sloped area by using the magnetic strip or by crea-
ting a non-grass pathway that is more than 50mm wide directly
beside the slope.
Recognition error.
Remove the obstacle is there is one. Using the magnetic strip or
by creating a non-grass pathway that is more than 50mm wide
on the lawn edge ensure that the mower functions correctly.
Landroid Vision operative
system crashes when
charging or on standby.
Software or display fault. Restart Landroid Vision.