Owner's Manual

33
EN
Quick reference
SYMPTOM CAUSE SOLUTION
Landroid Vision shuts
off when docking in the
charging pile.
Landroid Vision fails to charge
due to over temperature pro-
tection and is powered off.
Place the charging base in a shady area or wait until the tempe-
rature has cooled down.
Poor connection.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Landroid Vision stops in
the working area.
There is an obstacle in the wor-
king area.
Remove the obstacle from Landroid Vision’s working area.
The cutting height is set too low
for the length of the grass or the
grass is too dense.
Raise the cutting height and then gradually lower.
Landroid Vision flips over.
There is an inclined obstacle on
the lawn.
Exclude the obstacle from Landroid Vision’s working area.
Landroid Vision fails to
connect to the internet.
Please check your router has the
correct settings.
Make sure your router is 2.4GHz or 5GHz. If your router has two
settings, please enable the 2.4GHz or 5GHz band.
Make sure your router is set to 802.11 mode and wireless setting
is b/g/n mixed.
Make sure your router has the SSID Broadcast function enabled
when you connect the machine with the app.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect Landroid
Vision to the new network.
If you have a “Fritz! box” router, please make sure activate
“Allow communication between devices in same network” in the
settings.
Please check whether the router
is disconnected or WIFI SSID is
changed.
Make sure the router is connected and WIFI SSID is correct.
Your Landroid Vision
beeps when you are
adjusting “month / hour /
minute”
It is normal.
Anticlockwise the
to adjust.