Instruction Manual

10
(See Fig. D). To refit the bag, firmly push the mounting bracket
into the location on the sander housing (See Fig. E).
For best performance always empty the dust bag when it is half
full.
FLUSH SANDING FACILITY
Your sander can sand flush on three sides of the base-plate
which allows easy access to corners and edges of moulding
(See Fig. F).
ORBITAL SANDING
Your sander operates in small circular rotations which allows
efficient material removal.
Operate your sander in long sweeping movements across your
workpiece and even across the grain. For a finer finish, always
use a fine grain Sanding Paper and only move the sander in the
direction of the grain and never across the grain.
Do not allow your sander to remain in the same position
otherwise you will remove material and create and uneven
surface.
Work hints for your palm sander
If your power tool becomes too hot, run no load for 2-3 minutes
to cool the motor.
Always ensure the work-piece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of the
sanding finish.
7
8
F