User Manual

3) Fit the adapter onto the tool holder, then place the application tool

onto the adapter. Make sure that the tool holder, the adaptor, and the

application tool share a ﬂush ﬁt.

4) Reposition the fastening piece onto the application tool and tighten

with the Allen key.

Note: Make sure the adapter matches the application tool. The

adapter (I) is matched to the application tool of Fein

. The adapter (II)

is matched to the application tool of Bosch

.(See Fig. A3)

MOUNTING/CHANGING THE SANDING SHEET (See

Fig.

Align the sanding sheet and press it onto the sanding pad by hand.

Firmly press the power tool with the sanding sheet against a ﬂat

surface and brieﬂy switch the power tool on. This provides for good

adhesion and prevents premature wear.

If one point has become worn, pull off the sanding sheet, turn it 120°

and place it on again.

OPERATING THE ON/OFF SWITCH

To start the machine, push the On/Off switch (2) forward so that the

“I” is indicated on the switch.

To switch off the machine, push the On/Off switch (2) toward the

rear so that the “0” is indicated on the switch.

USING THE VARIABLE SPEED CONTROL

Select oscillation frequency (speed) while the motor is running.

The variable speed control (5) can be used to set the optimum

oscillating frequency according to the accessories used and the

respective application.

High oscillation frequency:

Sanding, sawing, rasping and polishing stone and metal.