Lithium-Ion Cordless Circular Saw EN P07 F P16 ES P25 WX523L WX523L.
13 1 12 11 2 10 3 4 5 9 8 6 7 14
A2 A1 1 2 B A3 1 3 2 17 15 C1 C2 2 1 16 18
D1 D2 E1 E2 E3 F1
F2 G1 G2 H
ACCESSORIES 1. SOFT GRIP HANDLE 2. FIXED UPPER GUARD 3. VACUUM ADAPTER 4. DUST EXTRACTION OUTLET 5. PARALLEL GUIDE CLAMPING FIXTURE 6. 7. WX523L WX523L.9 TCT 24T Blade 1 1 Parallel Guide 1 1 Vacuum Adaptor 1 1 Hex Key 1 1 Battery 1 / Charger 1 / PARALLEL GUIDE LOWER BLADE GUARD 8. BASE PLATE 9. LOWER GUARD LEVER We recommend that you purchase your accessories from the same store that sold you the tool. Refer to the accessory packaging for further details.
Save all warnings and instructions for future reference. The term power tool in the warnings refers to your electric (corded) power tool or battery-operated (cordless) power tool. WORK AREA SAFETY Keep work area clean and well lit. Cluttered or dark areas invite accidents. b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
5. BATTERY TOOL USE AND CARE a) Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. b) Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
near the edge of the panel. e) Do not use dull or damaged blades. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding and kickback. f) Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. g) Use extra caution when making a “plunge cut” into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback.
m) n) o) p) exposed metal parts of the power tool “live” and could give the operator an electric shock. Never lay the power tool down until the accessory has come to a complete stop. The spinning wheel may grab the surface and pull the power tool out of your control. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. Regularly clean the power tool’s air vents.
Li-Ion battery, battery must be recycled HSS blade Make sure the battery is removed prior to changing accessories. TCT blade Li-I on Wear protective gloves Wood Metal Aluminium POSITEC Inc. has established a partnership with the RBRC Corporation to recycle any Positec batteries with the RBRC-call2recycle seal. For environmental protection, please do not discard batteries in the trash.
WORKING HINTS FOR YOUR TOOL MAINTAIN TOOLS WITH CARE If your power tool becomes too hot, please run your circular saw no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very low speeds. Protect saw blades against impact and shock. Cutting with extreme force can significantly reduces the performance capability of the tool and reduces the service life of the saw blade. Sawing performance and cutting quality depend essentially on the condition and the tooth count of the saw blade.
www.worx.com Copyright © 2017, Positec. All Rights Reserved. Copyright © 2017, Positec. Tous droits réservés. © Derechos reservados 2017, Positec. Todos los derechos reservados.
