Use and Care Guide

1514
Cordless Circular Saw EN
14
MAINTAIN TOOLS WITH
CARE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
Periodically clear dust and chips from guard and base
to ensure proper performance.
TROUBLESHOOTING
Symptom
Possible
Causes
Possible
Solution
Tool will not
start when
operating the
on/off switch.
Battery pack
not securely
fitted into tool.
Battery pack is
not charged.
Make sure
battery is
fully charged
and securely
fit into the
tool.
Cutting depth
is less than that
is set.
Sawdust
accumulated
at the rear of
the base.
Blow out
sawdust.
Consider
connecting
a vacuum
for dust
collection.
Blade spins or
slips
Blade is
not tightly
engaged with
the spindle.
Remove the
blade, and
reassemble it
as described
in Saw
Blade
Assembly
and
Removing
section.
Blade will not
cut a straight
line.
Blade is dull.
Blade is not
mounted
properly.
Saw is not
being guided
properly.
Mount a new,
sharp blade
on the saw.
Check that
blade is
properly
mounted.
Use a parallel
guide.
Blade kicks
back when
beginning a cut
Blade is not
spinning fast
enough
Allow the
saw blade
to reach full
speed prior
to beginning
a cut in the
material.