Instruction manual

WX540
WX540.3 WX540.9
12V Li-Ion
multi-purposed saw
breakage.
Any cut which puts pressure on the blade,
such as angle or scroll cuts, increases potential
for vibration, kickback and blade breakage.
WARNING: Shock hazard. Use extra
caution when cutting overhead and pay
particular attention to overhead wires which
may be hidden from view.
WARNING: Use extra caution when
cutting overhead and anticipate the path
of falling branches and debris ahead of time.
WARNING: Inspect work site for hidden
gas pipes, water pipes, or electrical
wires before making blind or plunge cuts.
Failure to do so may result in explosion,
property damage, electric shock, and/or
serious personal injury.
WORKING HINTS FOR YOUR
mULTI-PURPOSED SAW
If your power tool becomes too hot, set the
speed to maximum and run no-load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds.
GENERAL
Always use a blade suited to the material and
material thickness to be cut.
Always ensure the work–piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect
the quality of the cut. The blade cuts on the
upward stroke and may chip the uppermost
surface.
Ensure your uppermost surface is a
non-visible surface when your work is
finished.
mAINTENANCE
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
The tool suddenly stops
during operation.
Over load
Battery temperature too high
Low battery capacity
Relieve the load on the machine
immediately and allow cooling for
approx. 30 seconds at the highest
no-load speed.
Charge the battery pack.