SAFETY AND OPERATING MANUAL Random orbital sander WX652 WX652.
General Power Tool Safety Warnings WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
4) Power tool use and care a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
16. Only use paper in good condition. Do not use torn or worn paper. 17. Do not sand material containing asbestos due to a health risk. 18. Do not sand lead based paint due to the risk of lead poisoning. 19. Do not eat or drink in the working area of the sander. 20. Do not allow people to enter the working area without wearing a dust mask. 21. Where possible, seal off the working area to contain the dust for later removal. 22. Your tool is designed for dry sanding only, not wet sanding. 23.
2 1 3 4 5 6 1. On/off witch 2. Hand grip area 3. Dust bag* 4. Dust extraction outlet 5. Latching lever 6. Base plate 7. Sanding paper* (See Fig. B) * Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA Voltage Power input No load speed 230-240V~50Hz 300W 12000/min Base size 125mm Orbital dia 2.5mm Protection class /II Machine weight 1.4kg ACCESSORIES Dust bag 60 grit velcro sanding paper 80 grit velcro sanding paper 120 grit velcro sanding paper 1 2 2 2 We recommend that you purchase your accessories from the same store that sold you the tool. Use good quality accessories marked with a well-known brand name. Choose the type according to the work you intend to undertake.
OPERATING INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. 1. CHANGING HOOK & LOOP SANDPAPER (See Fig. A, B) The sandpaper and sanding plate are provided with a hook and loop attachment system to allow quick and easy changing of the sanding and polishing accessories. Firstly, remove any dust or other objects from the hook and loop on the sanding plate and sandpaper.
Your sander is designed to be held either around the main housings, or by the top of the main housing. When sanding for long periods at a time, it is recommended you periodically alternate between the two holding positions. D E F G 5. SANDING SURFACES Place the machine with the complete Sand paper on the surface to be worked. Ensure uniform sanding pressure. Less sanding pressure increases the sanding capacity and protects the machine and the sanding tool.
grit) for finishing. If you use a fine grade for rough surfaces it will soon clog and need changing. — It is best to make a trial run on a scrap piece of material to determine the optimum grades of sandpaper for a particular job. 8. SANDING PLATE BRAKE An integrated sanding plate brake reduces the speed when running at no load so that scoring is avoided when placing the machine on the work piece.
Copyright © 2012, Positec. All Rights Reserved.