SAFETY AND OPERATING MANUAL Oscillating Tool WX680
HyperlockTM Accessory Clamping Lever On/Off Switch Variable Speed Dial Constant Speed Electronics Venting Slots Universal FitTM Accessory Interface * Flange Smaller Flange For other brands' sanding pads * Works with other oscillating tool brands' accessories.
A B 1 1 2 2 3 C D E1 E2 E3 E4
E3 E4 E5 F G ON OFF
TECHNICAL DATA Rated voltage Rated power 230-240V~50Hz 350W Oscillations speed 11000-20000 /min Oscillations angle 4.0° Protection class Tool weight (without power cable) /ll 1.
GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) WORK AREA SAFETY a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
4) POWER TOOL USE AND CARE a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
SYMBOLS To reduce the risk of injury, user must read instruction manual Wear protective gloves Double insulation High oscillation frequency. Warning Low oscillation frequency: Wear ear protection C-tick marking Wear eye protection RCM marking Wear dust mask 9 Before working with your tool make sure that no power cords will be damaged. Avoid danger of injury from the sharp edges of the accessories.
OPERATING INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. INTENDED USE The power tool is intended for sawing and remodelling wooden materials, plastic, plaster, non-ferrous metals and fasteners (e.g. nails and clamps) as well as for working on soft wall tiles and for dry grinding of small surfaces. It is especially suitable for working close to edges and for flush cutting. ASSEMBLY AND OPERATION Action 10 Figure Mounting accessories See Fig.
APPLICATION WARNING: The sawing teeth are very sharp. Do not touch during mounting and application. The workpiece must be clamped tightly before it is cut. Pic Sawing Description Application Bi-Metal Metal/Wood End Cut Blade Wood, plastic, fiberglass, nails, non-ferrous metals, thin sheet metal, hardened fillers. Standard Wood End Cut Blade Wood, plastic, drywall. Precision Wood Cut Blade Wood, soft plastics.
www.worx.com Copyright © 2014, Positec. All Rights Reserved.