Use and Care Manual

7
20V Cordless Brushless Oscillating Tool
EN
COMPONENT LIST
1. HYPERLOCK™ ACCESSORY CLAMPING LEVER
2. ONOFF SWITCH
3. VARIABLE SPEED DIAL
4. VENTING SLOTS
5. UNIVERSALFIT ACCESSORY INTERFACE
6. FLANGE
* Works with other oscillating tool brands’ accessories.
The following compatible brands are trademarks
owned by third parties which may be registered by their
respective owners: Black & Decker
®
, Bosch
®
, Chicago
Electric
®
, Craftsman
®
, Dremel
®
, Fein
®
, Genesis
®
, Makita
®
,
Mastercraft
®
, Milwaukee
®
, Performax
®
, Porter Cable
®
,
Ridgid
®
, Rockwell
®
, Ryobi
®
, Skil
®
, Starlock
®
and Tool Shop
®
.
Not all the accessories illustrated or described are
included in standard delivery.
TECHNICAL DATA
Type WX697L WX697L.X (6-designation of machinery,
representative of high frequency oscillation tool)
WX697L WX697L.X**
Voltage 20V Max***
Oscillations speed 8000-18000 /min
Oscillation angle 4 °
Machine weight(Bare tool)
2.27lbs ( 1.03kg)
**X may be followed by one or two characters. All models
are the same except model number and trademark.
The suffix in models may be number from “1” to “999”
or English letter “A” to “Z” or “M1” to” M9” which means
different package or the various of accessories packed in
the package.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.
Category Model Capacity
20V Battery
WA3520 1.5Ah
WA3525 2.0Ah
WA3575 2.0Ah
WA3578 4.0Ah
20V Charger
WA3742 0.4A
WA3875 2.0A
WA3881 2.0A
We recommend that you purchase your accessories from
the same store that sold you the tool. Refer to the accessory
packaging for further details. Store personnel can assist you
and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
This power tool is intended for cutting, sanding, scraping,
polishing and grinding various materials, using a
oscillating motion. Specific application depends on the
accessory being used. It is especially useful when working
in close to edges, flush and plunge cutting.
ASSEMBLY AND OPERATION
Action Figure
Mounting accessories See Fig. A-C
Mounting the sanding sheet See Fig. D
Operating the on/off switch See Fig. E
Using the variable speed dial See Fig. F
Remove or install battery pack See Fig. G
LED Light See Fig. H
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories used
and the respective application.
Oscillation
frequency
Application
High oscillation
frequency:
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Low oscillation
frequency:
Scraping, Polishing
Varnishes.