Use and Care Manual

Lithium-Ion Cordless Circular Saw EN
11
exposed metal parts of the power tool “live”
and could give the operator an electric shock.
m) Never lay the power tool down until the
accessory has come to a complete stop.
The spinning wheel may grab the surface and
pull the power tool out of your control.
n) Do not run the power tool while carrying
it at your side. Accidental contact with the
spinning accessory could snag your clothing,
pulling the accessory into your body.
o) Regularly clean the power tool’s air
vents. The motor’s fan will draw the dust
inside the housing and excessive accumulation
of powdered metal may cause electrical
hazards.
p) Do not operate the power tool near
flammable materials. Sparks could ignite
these materials.
GENERAL SAFETY WARNINGS
FOR BATTERY PACK
1) WARNING: Risk of fire and burns. Do not
disassemble, heat above 100°C (212°F),
or incinerate. Do not expose cells or
batteries to heat or fire. Avoid storage in
direct sunlight.
2) Dispose of used battery promptly.. When
disposing of secondary cells or batteries,
keep cells or batteries of different
electrochemical systems separate from
each other.
3) Keep battery out of reach of children and
in original package until ready to use.
4) Never put batteries in mouth. If
swallowed, contact your physician or
local poison control center.
5) CAUTION – The battery used in this
device may present a risk of fire or
chemical burn if mistreated. Replace
battery with WORX only. Use of another
battery may present a risk of fire or
explosion.
6) Warning: Do not use a visibly damaged
battery pack or appliance as applicable.
7) Warning: Do not modify or attempt to
repair the appliance or the battery pack
as applicable.
8) BATTERY MUST BE RECYCLED.
9) Do not short-circuit a cell or battery. Do
not store cells or batteries haphazardly in
a box or drawer where they may short-
circuit each other or be short-circuited
by conductive materials.
10) Do not subject cells or batteries to
mechanical shock.
11) Keep cells and batteries clean and dry.
Wipe the cell or battery terminals with a clean
dry cloth if they become dirty.
12) Do not maintain secondary cells and
batteries on charge when not in use.
13) Retain the original cell and battery
literature for future reference.
14) Do not use any charger other than that
specifically provided for use with the
equipment. Secondary cells and batteries
need to be charged before use. Always use the
correct charger and refer to the manufacturer’s
instructions or equipment manual for proper
charging instructions.
15) When possible, remove the battery from the
equipment when not in use.
16) Prevent unintentional starting. Ensure the
switch is in the off-position before connecting
to battery pack, picking up or carrying the
appliance. Carrying the appliance with your
finger on the switch or energizing appliance
that have the switch on invites accidents.
17) Disconnect the battery pack from the appliance
before making any adjustments, changing
accessories, or storing appliance. Such
preventive safety measures reduce the risk of
starting the appliance accidentally.
WARNING-To reduce the risk of injury,
user must read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain or water
Do not burn
SYMBOLS