User Manual

HELP & TROUBLESHOOTING
There is no
power.
Press the POWER button on the remote control or on the top of your Sound Bar.
Ensure the power cord is securely connected.
Plug a different device into the electrical outlet to verify that the outlet is working correctly.
I hear sound
cutting out.
See Page 22 for optimal source device settings.
Go to www. nakamichi-usa.com/audio-setting for the most updated list.
Contact: [e-mail] (we guarantee a response within 24 hours.)
The remote
isn’t working.
Replace the remote batteries with new ones.
Point the remote directly at the center of the Sound Bar when pressing a button.
If using a Bluetooth connection, some of the buttons on the remote may not be supported the streaming
application.(e.g., Pandora doesn’t support the Back button.)
Resetting the
SHOCKWAFE.
On the remote control, select HDMI ARC mode > Toggle SETUP button to “RESET” >
Press ENTER > Select “YES” > Press ENTER.
There is no
sound.
Increase the volume. Press Volume Up on the remote control or on the top of your Sound Bar.
Press MUTE on the remote to ensure the Sound Bar is not muted.
Press SOURCE on the remote or on the top of your Sound Bar to select a different input source.
When using either of the Digital Inputs, if there is no audio: (A) Try setting the TV output to PCM or
(B) Connect directly to your Blu-ray/other source, some TVs do not pass through digital audio.
Your TV may be set to variable audio output. Confirm that the audio output setting is set to FIXED or
STANDARD, not VARIABLE. Consult your TV’s user manual for more detailed information.
If using Bluetooth, ensure that the volume on your source device is turned up and that the device is not muted.
38