Installation Guide

1
2
3
Attach supply lines .
Do not overtighten.
Turn water back on.
1
3
Provided with necessary models.
Attach the mounting nut to the
hot and cold threaded mounting
shanks and tighten faucet to
basin.
2
Cold
Hot
Before installing the valves,
clean the water pipe thoroughly
to avoid dirt and deposits.
1
Notes
OPTION: Use silicone under the
base if deck is uneven.
1.Remove the washer (2) , black
gasket (4) and nut (5) from the
assembly.
2.Slide washer (2) up to underside
of flange (3).
Insert flange (3) and washer (2)
into sink and secure with the black
gasket (4) washer and nut (5) from
underneath the sink.
3.Put down and check the
Spring loaded stopper (1).
4. Connect assembly to drain.
1
2
3
4
5
To flush debris from the plumbing
system:
1. Remove the aerator by hand.
2. Run hot and cold water for
one minute.
3. Replace the aerator.
Repeat for other hose connection
making sure the hose with the hot
label is connected to the hot supply
valve and the other
hose is connected to the cold supply
valve.
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies
and flush water lines for one minute.
Check all connections at arrows for
leaks.
Retighten if necessary, but do not
overtighten.
4
5
6