Installation Guide

1.Attach pull-out hose (11) on quick
connects (9).
Press the quick connects firmly.
2. Attach weight ball(16) to pull-out
hose (11)
Make sure the pull-out hose is not
blocking by other objects and not
touching the ground.
The appropriate height for gravity
ball installation is 100mm.
3.Attach supply hot(8)and cool
lines(9) .
4. If the anglve is G1/2'', please
use 3/8'' standard pipe connection
G1/2'' adapter included (12) .
Do not overtighten. Turn water back
on.
2
9
16
11
8
10
12
or
1.Remove the brass lock nut (5) from
the thread rod counter-clockwise,
remove the washer (4) and washer (3)
1
2
4
1
4
5
2
3
6
Before installing the valves, clean the
water pipe thoroughly to avoid dirt
and deposits.
1
Check for Leaks
Turn on water and check all connections at arrows for leaks.
Refer back to the appropriate installation
instructions and retighten if necessary.
The sprayer can be removed by pulling
directly out from the spout.
5
NOT WITH
apply teflon
tape to
the quick
connect
installation.
model 1:Standard Flow Aerator
model 2:Spray
water flow pattern unchanged when
the water is turned off.
1. Make sure
attach the O-ring(2) to the faucet body.
2.Slide tubes down through mounting
hole andfaucet on sink.
Option: If sink is uneven, use silicone
under the gasket.
1
1.Use the triangle fastener(15)
when the thickness of sink <5mm.
2.Place Triangle fastener（15）
and washer(4) and metal plate(5)
over mounting stud(3) under sink.
Secure with mounting nut(6),
tighten the screws(7) to fix the
faucet body
5
6
3
4
7
15
3
ca. 100
ca. 100mm
To switch water flow mode quickly,
insert the sparyer with gear into the
pipe, rotate the areator to switch mode.