User's Manual

Battery details

Before you use Dragster for the rst time, or if you have depleted the batteries you will need to

insert fresh batteries. If Dragster slows down or is less responsive try changing the batteries; if it

does not respond to commands but moves quickly, try changing the batteries in the remote controller.

Battery requirements

Dragster requires 1 x “9.6V” size battery pack and the remote controller requires

1 x “9V” size battery. (The batteries are not included).

NOTE: Make sure the main power switch is set to OFF before changing the batteries.

To install the batteries in Dragster, do the following:

Locate the battery compartment door. Using a Phillips screwdriver (not included) remove 1.

the screw on the battery compartment door.

Insert the battery according to the diagram. Ensure that the orientation of the sockets 2.

are correct.

Replace the battery compartment door and replace the screw using the screwdriver. 3.

Do not over-tighten.

9.6V

800m

OR MORE