User's Manual

4
Battery details
To install the battery in the remote controller, do the following:
Locate and open the battery compartment door on the remote controller. Using a Phillips 1.
screwdriver (not included) remove the screw on the battery compartment door.
Insert the battery according to the diagram. Ensure that the positive and negative 2.
polarities match the illustrations inside the battery compartment.
Replace the battery compartment door and replace the screw using the screwdriver. 3.
Do not over-tighten.
Important battery information
Use only fresh batteries of the required size and recommended type•
Do not mix old and new batteries, different types of batteries [standard (Carbon-zinc), Alkaline or rechargeable] or •
rechargeable batteries of different capacities
Remove rechargeable batteries from the toy before recharging them•
Rechargeable batteries are only to be charged under adult supervision•
Respect the correct polarity, (+) and (-)•
Do not try to recharge non-rechargeable batteries•
Do not dispose batteries in a re•
Replace all batteries of the same type/brand at the same time•
The supply terminals are not to be short-circuited•
Remove exhausted batteries from the toy•
Batteries should be replaced by adults•
Remove batteries if the toy is not going to be played with for some time •
9V