User's Manual

CHARGING
OFF
Battery Diagram/Installation
LED
Power
Micro USB
DC IN 5V 0.5A
For Lithium-ion Batteries:
BATTERY INFORMATION
4817US01TOP_MIM
WARNING! This product is not suitable for children under 3 years because
of small parts - choking hazard.
CAN ICES-3(B)/NMB-3(B)
MADE IN CHINA
CAUTION
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
Installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or experienced radio/TV technician for help
This Device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may
cause undesired operation of the device.
ON
3 x 1.5V “LR44 / AG13”
Button Cell Batteries (included)
Installing or changing batteries in Cheese Control:
Lay Cheese Control down so that the battery compartment
faces upwards. Cheese Control requires 3x1.5V
“LR44/AG13” Button Cell Batteries (included).
BATTERY REPLACEMENT
1. Remove the screw to access the battery compartment.
2. Open battery door.
3. Exhausted batteries are to be removed.
4. New batteries are to be inserted with correct polarity.
5. Replace the battery door and secure with screw.
BATTERY INSTRUCTIONS
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or
rechargable (nickel- cadmium) batteries.
Non-rechargable batteries are not to be recharged.
The supply terminals are not to be short circuited.
Do not use rechargable batteries.
Remove batteries when not in use or discharged
* Remy/Emile is operated by 1 x 3.7V 150 mAh Lithium-ion rechargeable
Recharging Remy/Emile:
1. Plug the Micro USB Cable into the
Micro USB port on Remy/Emile and
connect to a power source as
indicated in the diagram.
2. Charging is indicated by a flashing
red light.
3. When fully charged, the light on
Remy/Emile will appear stop
flashing.
WowWee Group Limited. Energy Plaza, 301A-C, 92 Granville
Road, T.S.T. East, Hong Kong
WowWee Canada Inc. 3700 Saint Patrick Street, Suite 206,
Montreal, QC, H4E 1A2, Canada
Customer Service: https://support.wowwee.com
Age: 3+
© 2020 WowWee Group Limited.
All Rights Reserved. Patent Pending.
1
2
3