Instructions

45
EN
(20)
22
20
21
(6)
(5)
(17)
(17)
7.10 Mounting the roller shutter (17)
ATTENTION!
Drilling and inserting
screws in the area of the
drive will cause the drive
to be damaged.
◆ Never drill or insert screws in the area of the drive
(9) in order to secure the roller shutter (17).
1. Mount a shaft connector (6) at both ends of the
winding shaft (5).
In order to do so, follow the information provided in
the operating manual for shaft connectors.
4. Finally, mount two roller shutter stoppers (20) or
an end-rail onto the lowermost slat or rail of the
roller shutter (17).
ATTENTION!
The roller shutter may run into the roller shutter
box in self-learning mode and be damaged with-
out rigid shaft connectors and stoppers.
◆ Connect the roller shutter (17) to the winding
shaft (5) with rigid shaft connectors (6).
◆ Always fit two stoppers or an
end-rail to the roller shutter (17).
2. Slide the retainer profile for each shaft connector (6)
onto the uppermost slat of the roller shutter (17).
3. Subsequently slide each retainer profile over a
shaft connector (6).