Instructions

31
EN
Contents
1. This manual... ............................................32
2. Hazard symbols .........................................32
2.1 Levels of danger and signal words ......32
2.2 Symbols and depictions used ...............32
2.3 Glossary - Definition .................................33
3. Scope of delivery for RolloTube C-line
Small/Medium ...........................................34
4. General view of the RolloTube C-line
for Small/Medium .....................................35
5. Functional description ..............................36
5.1 Blockage detection function .................36
6. Safety instructions ....................................37
6.1 Intended use / operational
conditions .....................................................38
6.2 Improper use ...............................................38
6.3 Required expert knowledge of
the installer ..................................................38
7. Important assembly instructions ............39
7.1 Installation of the tubular motor..........39
7.2 Mounting the bearings ............................40
7.3 Determining the length of the
winding shaft (5) ........................................40
7.4 Mounting / dismantling the
adapter (10)..................................................41
7.5 Mounting /dismantling the drive
adapter (8) ....................................................41
7.6 Sliding the tubular motor (9) into
the winding shaft ....................................... 42
7.7 Preparation for use of the precision
tubes ..............................................................42
7.8 Mounting the roller capsule (4) ............44
7.9 Mounting the motor into the
bearing ..........................................................44
7.9.1 Mounting into the drive bearing
as a click bearing (13) ...................44
7.9.2 Mounting in other drive
bearing versions ............................44
7.9.3 Mounting into the counter
bearing (1) ........................................44
7.10 Mounting the roller shutter (17) ...........45
8. Safety information regarding the
electrical connection.................................46
8.1 Safe cable routing by fixing the
plug connection .........................................47
8.2 Connecting the motor cable (15) .........47
8.3 Electrical connection of the
tubular motor ..............................................48
8.3.1 Control of a drive from a single
point with a 1-pole switch /
button ................................................48
8.3.2 Parallel connection of
several motors ................................48
8.4 Connecting a cord-switch setting
unit for the manual adjustment
of end points ...............................................49
9. Self-learning mode with soft stop ...........50
10. Manual adjustment of end points ...........50
10.1 Test run / modifying the end points ...52
11. Loading factory settings during the
commissioning process ............................52
12. What to do if... ? .........................................53
13. Technical specifications ............................54
14. Configuration of KNX/EIB Venetian
blind actuators for RADEMACHER tubular
motors ........................................................54
15. Simplified EU declaration of
conformity .................................................55
16. Warranty terms and conditions ...............55
i