Instructions

38
EN
6.1 Intended use / operational conditions
Only use the tubular motors for opening and closing
standard flat roller shutters and awnings.
Operating conditions
◆ A 230 V / 50 Hz power supply, together with a
site-provided isolating device (fuse) must be per-
manently available for the electrical connection at
the installation location.
◆ The roller shutter must run up and down smoothly.
It should not jam.
Operational conditions for the self-learning
mode and for the correct functioning of the
blockage detection.
◆ The roller shutter must be mounted to the wind-
ing shaft with rigid shaft connectors (6), see page
45.
◆ The roller shutter must be fitted with stoppers or
an end-rail, see page 45.
6.2 Improper use
Never use the tubular motor in systems with in-
creased safety-relevant requirements or where
there is an increased risk of accidents.
◆ Such applications require additional safety equip-
ment. Observe the respective statutory regulations
for the installation of such systems.
The use of the wrong tubular motors or compo-
nents can lead to property damage.
◆ The motor cable must therefore be fitted with a
suitable empty tube up to the respective junction
box under observation of local electrical regula-
tions, if installed outside.
◆ Only use the manufacturer's original parts and
accessories.
◆ Only use tubular motors which correspond to
the local conditions in terms of their power.
Incorrectly dimensioned tubular motors can lead
to damage:
> An insufficiently dimensioned tubular motor
can be damaged due to overloading.
> An excessively dimensioned tubular motor
can,
for example, cause damage to the roller shut-
ter or roller shutter box in self-learning mode.
◆ Consult a specialist dealer when selecting a
tubular motor and observe the corresponding
tractive force specifications on our website:
www.rademacher.de
Never use the tubular motor in continuous opera-
tion. Doing so will cause serious damage.
6.3 Required expert knowledge of the installer
i
i
The installation, electrical connection and main-
tenance must be carried out by a qualified person
with appropriate training or by a specialist roller
shutter firm in accordance with the instructions in
this manual.
Using the RolloTube C-line for purposes other than
previously mentioned is impermissible.
Never use the tubular motor for shutters with
openings of ≥ 50 mm in diameter.
i