Instructions

42
EN
11
(10)
(8)
(9)
(5)
9
10
1. Measure the distance between the adapter (10) and
the rear third of the drive adapter (8) and mark this
distance on the precision tube.
i
Please only use precision
tubes made from aluminium.
◆ The following steps can be left out
when using octagonal steel shafts.
ALUMINIUM
7.7 Preparation for use of the precision tubes
7.6 Sliding the tubular motor (9) into the winding shaft
ATTENTION!
Inserting the tubular motor
(9) forcibly into the winding
shaft (5) will cause serious
damage.
◆ Never knock the tubular
motor (9) with force into
the winding shaft (5).
1. First slide the drive adapter (8) into the winding
shaft (5).
i
The motor (9) must have sufficient free
space for winding shafts with internal felt.
2. Subsequently, press the winding shaft (5) fully
onto the adapter (10).
ATTENTION!
◆ In doing so, ensure that the adapter (10) does
not slip off the magnetic ring (18) on the drive
head (12) during the assembly process. Other-
wise malfunctions may occur, see page 53.
◆ The motor must always be pushed fully into
the winding shaft. The length compensation or
correction is configured with the position of the
roller capsule, see page 44.