Instructions

44
EN
18
(11)
(12) (13) (14)
(5)(4)
(1)
(2)
19
(2)
(3)
(4)
(5)
17
7.8 Mounting the roller capsule (4)
1. Slide the roller capsule (4) into the winding shaft (5)
and subsequently place the ball bearing (2) onto the
axle pin (3) of the roller capsule.
7.9 Mounting the motor into the bearing
i
The tubular motors can be fitted into the
click bearing (13) in 4 positions.
◆ The motors can be released from the
click bearing (13) at any time by means
of expanding the retaining spring (14).
7.9.1 Mounting into the drive bearing as a click bearing (13)
1. Press the drive head (12) lightly into the click bear-
ing (13) until it engages. The set button (11) must
be easily accessible.
Hook the drive head (12) into the corresponding
drive bearing and secure, for example, with a cotter
pin.
7.9.2 Mounting in other drive bearing
versions
7.9.3 Mounting into the counter bearing (1)
1. Insert the other end of the winding shaft (5) with the
ball bearing (2) into the counter bearing (1).
2. In the event that you are using a different bearing
than the RADEMACHER click bearing (13), you may
need to secure the drive with a secondary cotter pin.
3. Correct any slight inaccuracies in size by means of
sliding the roller capsule (4) in or out.
i
The roller capsule (4) must be inserted at
least 2/3 of its length into the winding
shaft (5).
4. Finally, secure the roller capsule (4) with a screw.