Instructions

50
EN
CAUTION!
Risk of crushing injuries to the hand when work-
ing with the roller shutter box open.
◆ Never reach into the area of the winding shaft
when the motor is running.
ATTENTION!
The roller shutter may be damaged in case of
incorrect manual adjustment of the end points.
◆ Never dismantle the mechanical stoppers from the
final roller shutter slat.
◆ Do not allow the shutter to knock against the
mechanical stoppers and maintain a safety gap
of 2 - 3 cm.
9. Self-learning mode with soft stop
WARNING!
Risk of fatal injury (electric shock) due to tear-
ing off the motor cable (15).
◆ Ensure that the motor cable (15) is not taken up
by the winding shaft (5) or torn off during the
configuration process.
Important conditions for adjusting the end
points and for safe operation
◆ End points must be set in order to switch off the
motor when they are reached for both directions
of travel, up (▲) / down (▼).
◆ The tubular motor must be fully installed.
◆ There must be a suitably fixed limit (e.g. a win-
dow sill) in the area of the lower end point if the
end point is to be configured automatically.
You can also adjust the end points manually
if required:
◆ Manual adjustment of the upper and lower end
point, e.g. during the initial installation.
◆ Manual adjustment of an end point in combina-
tion with the self-learning mode.
The RolloTube C-line is delivered from the factory
in self-learning mode with a soft stop and can be
put into operation immediately after the electrical
connection.
10. Manual adjustment of end points
1. Switch on the mains power supply.
The RolloTube C-line is ready for operation imme-
diately.
2.
▲
▼
Move the roller shutter up and down.
The end positions for the soft stop are
automatically learned during the first
drive cycles.
3. Subsequently check the direction of travel of the
roller shutter.
Switch the lines for the direction of rotation if the
direction of travel is wrong, see connection diagram
[ 27 ] on page 48.
ATTENTION!
The roller shutter may run into the roller shutter
box in self-learning mode and be damaged with-
out rigid shaft connectors and stoppers.
◆ Connect the roller shutter to the winding shaft
(5) with rigid shaft connectors (6), see
page 45.
◆ Always fit two stoppers or an end-rail to the
roller shutter, see page 45.
◆ Never dismantle the mechanical stoppers from
the final roller shutter slat.
When using as an awning drive:
You must adjust the lower end point manually
when using the RolloTube C-line as an awning
drive.
The upper end position can then be adjusted in
self-learning mode.
Initial installation
At the initial installation, the roller shutter engineer
can carry out the end point setting with the help
of the set button (11) on the motor or with a com-
mercially available cord-switch setting unit (21).
Further information can be obtained from the cord-
switch setting unit operating manual.
Subsequent modification of the end points with
external controllers
If you want to subsequently modify the end points of
your tubular motor, you can adjust these with your
roller shutter controller (e.g. Troll Comfort).