User manual

EN
50
Configuring tubular motors
The tubular motors can be individually configured with the help of a cord circuit setting
unit (22).
The following configurations are possible.
◆ Reload the factory settings.
NOTE
Additional settings can be undertaken with the optionally available RT ConfigTool. Please
refer to the information on our Website (www.rademacher.de).
Automatic end point configuration is available again once the factory settings have
been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor must previously have been disconnected from the
power.
Loading factory settings during the commissioning process
2.
Additionally switch on the mains power. Hold all buttons.
First press and hold the set button (11) on the tubular motor and subsequently press and hold the SET button on
the cord circuit setting device (22) (possibly a second person carries this out).
3. After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up
and down.
10 s
A. B.+
Factory settings:
End points: No end points stored
Automatic adjustment of the end points: activated
Reversing after obstacle detection: activated
Reversing after blockage detection: activated
Shutter length compensation system: activated
4. Release the set button (11) on the tubular motor and the SET button (or the external switch, if connected).
Switch off the mains power.
If a cord circuit setting unit (22) is being used, then the rocker switch must be positioned to the centre position.
1.
OFF
or
Symbols and actions when connecting a cord circuit setting unit (22)
or
when connecting an external switch.
or
SET
ON
or
or
SET
5. Switch off the mains power again.
OFF
or