User manual
38
EN
STOP
5.d
5.e
5.f
3.
5.
4.
1.
Preparation for use of precision tubes (Figures
-
)
Slide the tubular motor into the precision tube.
Mark the four fastening holes and subsequently drill them through the
precision tube in the catch (8).
ATTENTION
◆ Never drill deeper than 10 mm into the catch (8).
◆ Never drill in the area of the drive. Doing so will cause serious
damage.
Screw or rivet the precision tube to the catch (8).
Use four self-tapping sheet metal screws or four pop rivets.
Inserting the bearing capsule (Figure
)
Slide the bearing capsule (4) into the rotating union (5) and subsequently
place the ball bearing (2) onto the axle pin (3).