User manual
51
EN
i
Small Medium
6/28
6
28
230
50
121
0.53
4
5
0.75
3
32
H
I
IP 44
PVC
485
35
3
i
10/16
10
16
230
50
112
0.49
4
5
0.75
3
32
H
I
IP 44
PVC
487
45
2
10/16
10
16
230
50
121
0.53
4
5
0.75
3
32
H
I
IP 44
PVC
485
35
3
20/16
20
16
230
50
145
0.64
4
5
0.75
3
32
H
I
IP 44
PVC
487
45
2
30/16
30
16
230
50
191
0.83
4
5
0.75
3
32
H
I
IP 44
PVC
546
45
2
50/12
50
12
230
50
205
0.89
4
5
0.75
3
32
H
I
IP 44
PVC
546
45
2
40/16
40
16
230
50
198
0.86
4
5
0.75
3
32
H
I
IP 44
PVC
546
45
2
Technical specifications
Motor series
Type:
[Nm] Rated torque:
[RPM] No-load speed:
[V] Rated voltage:
[Hz] Frequency:
[W] Rated output:
[A] Power consumption:
[Min.] Cyclic duration factor (KB):
Number of wires:
[mm
2
] Core cross section:
[m] Cable length (standard):
[U] Limit switch range: (number of revolutions)
Insulation class:
Protection class:
Protection class in accordance with VDE 700:
Conduction class:
[mm] Motor length without bearing:
[mm] Tube diameter:
Number of parallel tubular motors connectible (when using
RADEMACHER controllers, e.g. Troll Comfort)
Configuration of KNX/EIB blinds actuators for RADEMACHER tubular motors
in order to ensure trouble-free operation of RADEMACHER tubular motors with KNX/EIB
blinds actuators, the following parameters must be configured prior to commissioning:
Transient operation
If possible, transient operation (lamella adjustment) should be switched off.
e.g. Mode for transient operation
Time: = 0 ms
If transient operation cannot be deactivated from within the software
application...
...then you must ensure that the time between transient operation and long-term opera-
tion on the key sensor is less that the time between transient operation and long-term
operation on the actuator.
This will ensure that transient switch-off of the actuator is prevented when holding the
sensor key down.
Long-term operation
The motor must be switched off at the latest after 180 seconds.
e.g. Basis for long-term operation
Basis: = 2.1 s
Factor: = 86
= (2.1 s x 86 = 180.6 s)
i
CE Mark and EC Conformity
Tubular motors of series RolloTube Intelligent Small and Medium (item numbers.:
2640 06 95 / 2640 10 95 / 2660 10 95 / 2660 20 95 / 2660 30 95 / 2660
40 95 / 2660 50 95) complies with the requirements of the current European and
national directives:
2006/42/EC Machinery directive
2006/95/EC Low-voltage directive
2004/108/EC EMC directive
Conformity has been verified. The corresponding declarations and documentation are
available on file at the manufacturer’s premises.
RADEMACHER Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)