Installation Guide

ManualsBrandsWRIGHT PRODUCTS ManualsMotion & Light Sensor AdaptersWhite Screw-in Motion Sensor

INSTALLATION INSTRUCTIONS FOR DOOR ACTIVATED LED LIGHT

WITH WIRED SENSORS

Connect LED light to bracket by rmly pressing the socket on

the back of the light onto the ball on the bracket.

Make sure the LED light is pointing in the direction that

requires additional light, and if necessary, carefully tighten

the socket screw to ensure that the LED

light will not self-adjust with door

vibration.

Remove light from package.

With a #2 Phillips screwdriver,

remove the (2) screws

fastening the back of the light

to the light housing.

Insert (2) size AA batteries

(not included) into the light as

shown.

Open your storm door a few inches, and slide

the hold open bracket to the hold open position.

Make note of the location of the screws holding the door bracket to the door.

Loosen both screws that hold the door bracket to the door approximately

1/8” using a #2 phillips screwdriver.

Slide mounting bracket under door bracket, making sure that both screws

engage the slot.

Double check to ensure that the door bracket has not moved in relation to

the two screws fastening it to the door, re-tighten the screws.

Re-install the pin that connects the door bracket to the closer, open the door

slightly further, and disengage the hold open bracket.

With the door closed, locate the position you wish to fasten the switch and

switch activator. These should be spaced no more than 1/8" to 1/4" apart from

one another (see graphic at right).

NOTE: Before installing the wired switch, clean the door surface with alcohol.

The wired switch will be fastened to the door with supplied hook and loop

fastener.

Before installing the unwired switch activator, clean the door frame surface

with alcohol. The unwired switch activator will be fastened to the door frame in

close proximity to the wired switch with the supplied hook and loop fasteners

Now remove the plastic covering the adhesive portion of the hook and loop

fasteners, and apply to both the switch and the switch activator, and then stick

each piece to the location that you have previously tested.

Your installation is now complete.

NOTE: The light will only activate during low light/no light hours, once the connection between the two activation switches is broken by the door being open.

Remove the pin that connects the closer to the door bracket.

Re-attach the back of the light to the

back housing using the (2) screws.

SWITCH ACTIVATOR

SWITCH

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR DOOR ACTIVATED LED LIGHT WITH WIRED SENSORS 1 Remove light from package. With a #2 Phillips screwdriver, remove the (2) screws fastening the back of the light to the light housing. Insert (2) size AA batteries (not included) into the light as shown. 2 Re-attach the back of the light to the back housing using the (2) screws. 3 Open your storm door a few inches, and slide 4 Remove the pin that connects the closer to the door bracket.
PAGE 2
INSTALLATION INSTRUCTIONS FOR DOOR ACTIVATED LED LIGHT WITH INTEGRATED SENSOR 1 With a #2 phillips screwdriver, remove the (2) screws fastening the back of 2 Re-attach the back of the light to the 3 Open your storm door a few inches, and slide 4 Remove the pin that connects the closer to the door bracket. 5 Make note of the location of the screws holding the door bracket to the door. 6 Connect LED light to bracket by firmly pressing the socket on the light to the light housing.