Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings, Inc., its susidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
33
Installation Guide for SecureMesh
®
CONN-2000 - PL-0689A
l Power-on mode: Upon connecting to the power supply, the Status, LAN,
WAN, and RSSI LEDs flash white in unison. Then, one at a time in sequence,
the LEDs flash from blue to green.
l When the Status and RSSI LEDs are steady and green, the device is linking
to the wireless network and actively communicating, or it is already linked.
See Table 4 for more information on each status.
Cold Conditions
In extremely cold conditions, the radio module must self-warm before the CONN-2000
can be used. This process may take several minutes, depending on the environment.
While waiting for the unit to warm up, all LEDs should be solid green except for the
WAN LED. The WAN LED should flash from green to yellow. The red LEDshould
cycle on to off, and the green LED is always on. In addition, status messages display
on the console as the device is warming.
l The Cold threshold should be set from -10 to -20 °C
l The Heater Off threshold should be set from 0 to -10 °C
Fine Tuning the Alignment
The CONN-2000 has a signal strength mode that can be used to fine tune the angular
alignment of the device during installation. Enter the mode and use the LEDs as a sig-
nal strength indicator; slowly adjust the angles to optimize the signal strength.
Example Scenario
1. Press the reset button for less than two seconds to enter into alignment mode.
2. Observe the signal strength displayed by the LED pattern.
3. Slowly adjust the CONN-2000 mounting angles to maximize the signal
strength displayed by the LEDs.
l If the LEDs indicate more blue or green, then the signal strength is
stronger.
l If the LEDs indicate more yellow, then the signal strength is weaker.