Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings, Inc., its susidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
38
Installation Guide for SecureMesh
®
CONN-2000 - PL-0689A
Action
Amount of Time to
Press and Release the
Reset Switch
Notes
The other three LEDs indicate
RSSI level in 3 dB steps.
Remove from
antenna alignment
Press for < 2 seconds and
release
Reboot Press for 5 - 15 seconds
Reset to factory
defaults and reboot
Press for 30+ seconds
Accessing the CLI using WiFi
The CLI interface to the CONN-2000 is provided by an internal WiFi module. The mod-
ule enables a WiFi connection to the CONN-2000 using a Service Set Identifier/Pre-
Shared Key (SSID/PSK). After establishing a connection via WiFi, a Telnet con-
nection can be opened by using a pre-configured IP address as described in the fol-
lowing tables (Table 6, Table 7, Table 8, and Table 9).
Use the following list of commands to configure the Serial to WiFi parameters manu-
ally, to change the active configuration, and or the persistent configuration.
Note: Changing the active configuration will cause the Serial to WiFi
module to reset.