User's Guide

DynaGateway User Guide- Version 1.2 (04/032022)
RMP - Publication controlled by SGI
Figure 17 - Collection configuration screen
5.2 Configuring the
associated spots
Once the desired spots have been selected, two parameters
need to be configured for each. Both parameters can be modified
by selecting the icon, located on the far right side of each
registered spot. A screen to edit the spot configurations will open
(Figure 17).
1) Collection: time interval in which the Gateway will connect
with the DynaLogger of the selected spot. In other words, with what
frequency it will collect the data measured by that DynaLogger. The
interval between collections needs to be defined and it’s also
possible to define the start time of the Gateway collection.
It’s important to know the difference between the collection
interval and the sample interval. Collection interval is with respect
to the Gateway and sample interval concerns the DynaLogger. The
measurements collected by the DynaLogger are obtained according
to the sample interval and are stored in the internal memory of the
sensor until the Gateway, based on the collection interval, performs
a collection and clears the memory of the DynaLogger.
2) Spectral analysis: time
interval in which the Gateway will
connect with the DynaLogger of
the selected spot to obtain a
spectral analysis. It’s necessary to
define the interval between
spectra and also the start time for
the first spectrum to be
performed. In addition, it’s
possible to choose on which axes
the spectrum will be done,
according to the image on the left.
16