User's Guide

DynaGateway User Guide- Version 1.2 (04/032022)
RMP - Publication controlled by SGI
4.2 Communication Interface
After connecting to the power supply, the communication
interface of the DynaGateway with the internet must be configured.
To do this, the device’s “Configuration” mode must be initiated, by
executing the following steps:
1. Press and hold the “Config AP” button for 7 seconds (Figure
2). On release, the Network LED will turn yellow.
2. On a computer close to the DynaGateway, connect to the
Wifi network generated by the device (Figure 3), identified as:
- SSID (Name): Serial number of the DynaGateway, recorded on the device
- Password: Consult Dynamox support
05
Config AP Button
Figure 1 - Connection terminals
12/24 V
GND
Figure 2 - Configuration button
12Vdc ~24Vdc - 3A