User's Guide

DynaGateway User Guide- Version 1.2 (04/032022)
RMP - Publication controlled by SGI
09
In the “GSM” section, insert the APN, Login and Password used
by the operator (Figure 8). This information can be obtained from
the operator. The chip needs to be unblocked and have an active
internet package.
When this interface is used, the Network LED will turn red
when the connection is successful.
*
Available on DUO and LRD versions.
Figure 8 - LTE interface
4.2.3 Ethernet (LED: Blue)
To use the Ethernet interface, a network cable is required
to be connected to the bottom part of the DynaGateway (Figure 9).
If the user opts to use the DHCP service on their network,
no additional configuration is necessary. Just check the option “use
this interface” in the Ethernet section. When setting the IP for the
DynaGateway, it will also be required to define the IP that the device
should use.
For operation with an Ethernet network, a network release is
necessary. When this interface is used, the Network LED will turn
blue when the connection is successful.