Owner Manual

a. Tuck wires back into the
electrical outlet box.
b. Attach fixture to mounting
bracket. Tighten cap nuts to
hold fixture to the ceiling.
c. Remove roof assembly screws.
Remove roof and insert bulb.
Reattach roof.
(See illustrations below.)
d. Our fixtures have a photocell which
determines day from night and
causes the motion detector to work
only at night.
Mount Pendant to Ceiling
Crossbar
Fixture Screws
Bulb Installation
assembly screws or screw caps on roof (or underneath
roof) and insert bulb(s). Reattach roof (see figure 1).
b. For fixtures with an open bottom, simply install
the bulbs through the opening in the bottom
of the fixture (see figure 2).
c. For other fixtures, unscrew bottom finial while
securing the cage so that it doesn’t fall. Lower
the cage and insert bulbs. Reattach cage and
tighten bottom finial. (see figure 3).
d. Turn power on.
Figure 2
Open Bottom
Figure 3
Finial Bottom
Roof
Assembly
Screws
Figure 1
Two Screw Assembly
Connect to
Black Source
Wire
Connect to
White Source
Wire
1
2
3
Ground Screw
Black Source Wire
Wire Nuts
Ground Wires
White Source Wire
Wire Pendant to Outlet
Interior/Exterior
Lighting
a. Take the source wires and the ground wire from the
pendant and weave them through the chain (going in
and out of every other piece of chain - see the pendant
illustration below). Twist together white source wire
with white labeled fixture wire. Next, twist together
black source wire with black labeled fixture wire. Use
wire nuts (which should be included in your outlet
box) to secure connections.
b. Connect fixture ground wire (if provided) and outlet
ground wire to ground screw on crossbar as shown in
diagrams, by first wrapping outlet ground wire
around the ground screw, tighten ground screw,
leaving approximately 2 to 3 inches in excess beyond
ground screw. Finally, twist together outlet ground
wire with fixture ground wire using wire nuts.
Cap Nut
Cap Nut
E2
E3
Cage
Finial
a. For two screw assembly roofs, remove