Assembly Instructions

Step 2
Open the carton and place all the parts onto a clean, non-marring surface.
Place the Seat (H) facedown.
Attach Leg(G) to Seat(H) using Bolts(①) and washer (③)with Allen Key(④) as shown above.
Do not fully tighten the Bolts.
Attach another Leg(G) to Seat(H) using Bolts(①) and washer (③)with Allen Key(④) as shown
above.
Place the Chair on a LEVEL SURFACE.
Inspect it and make sure all Leg are adequately connected.
Gently and carefully press onto the chair with both your hands, this will help to align all parts
at all joints.
Then get off the chair, and in a sequential manner, proceed to tighten all Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one, this may cause the frame to
warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Step 1
Page 3 OF 7