Caution : You should read this before proceeding Please look in chair base for hardware pack.
B Label Chair Base Picture 1 Description QTY ① Flat Washers (φ6mm) 5 ② Spring Washers (φ6mm) 5 ③ Screws (M6x20mm) 5 ④ Allen Key 1 Before Beginning Assembly: Page 2 OF 5
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 2 Place the Chair Seat (A) with its bottom side facing upwards onto a clean, soft surface to avoid any scratches or damage to the product. Align the Mounting Position of the Chair Seat (A) with the Mounting Position of the Chair Base (B) as shown above. Then, affix the Chair Seat (A) to the Chair Base (B) using Flat Washers (①),Spring Washers(②),Screws (③) and the Allen Key (④). DO NOT FULLY TIGHTEN THE SCREWS AT THIS TIME.
Turn the Chair up.Place the Chair on a LEVEL SURFACE.Inspect it and make sure all parts are adequately connected.Gently and carefully, sit in the Chair.This will help align all the parts at all the joint areas. Then get off the Chair, and in a sequential manner, proceed to tighten all screws.Please turn each screw 6 times, so it is neither too loose nor too tight.To tighten the Screws, do secure assistance from your adult partner(s).
