Installation & Assembly

Turn the Chair up.Place the Chair on a LEVEL SURFACE.Inspect it and make sure
all parts are adequately connected.Gently and carefully, sit in the Chair.This will help
align all the parts at all the joint areas.
Then get off the Chair, and in a sequential manner, proceed to tighten all
screws.Please turn each screw 6 times, so it is neither too loose nor too tight.To
tighten the Screws, do secure assistance from your adult partner(s).
You may be required to turn the Chair, to gain easy access to the secure points.Turn
the Chair in a synchronised manner.
CAUTION 1: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then move towards the next one.
This could cause the frame to warp. If the chair wobbles after tightening, loosen the
screws and execute this same process.WARNING!! IF the Chair IS NOT STABLE , IT
COULD LEAD TO DAMAGING THE PRODUCT.Ensure all screws are fully locked
into position.The Chair is ready to be used.
Caution 2: This Chair can only be used on a flat, level surface.
Care & Maintenance
Page 5 OF 5