Caution: You must read this before you proceed Table Label Description QTY A Left Leg 1 B Right Leg 1 C Table Top Frame (with Suction Cups) 1 D Glass Top 1 Description QTY E Bolt:M6*20MM 9 F Allen Key 1 Label Picture Picture
Before Beginning Assembly: Step 1 Take out the silders in the four ends of Table Top Frame(C ) using Allen Key(F).
Step 2 Open the carton and place all the parts on a clean, non-marring surface. Attach the Table Top Frame(C) to the Left Leg(A) using Bolt(E) and Allen Key(F) as shown in the picture. Loosely tighten the Bolts. Caution: The Table and its Parts are Heavy. Two adults are required for lifting and moving them. Step 3 Attach the Table Top Frame(C) to the Right Leg(A) using Bolt(E) and Allen Key(F) as shown in the picture. Loosely tighten the Bolts. Caution: The Table and its Parts are Heavy.
Step 4 Stand up the table, check stability and then tighten the bolts. Note DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, In a sequential manner, gradually tighten each Bolt until all bolts are evenly secured. This methodology will ensure maximum evenness once all Bolts are fully tightened. Step 5 Place the Glass Top(D) on the assembled Table Frame. Caution: The Table and its Parts are Heavy. Two adults are required for lifting and moving them.
