Assembly & Installation Instrutions

ManualsBrandsWrought Studio ManualsCeiling LightsDeandra 1 - Light Single Square / Rectangle Pendant

1. Thread the fixture mounting screws through mounting plate, and then

secure them with two lock nuts. Adjust the length of fixture mounting

screws if necessary.

2. Attach mounting plate to the outlet box using two mounting screws.

3. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod, and then

secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure the

middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the

upper rod onto the middle rod using the threaded pipe.

Note: Length adjustable from 15-1/4" to 57-1/4". Use

fewer rods if shorter length is desired.

Thread the fixture wire through the fixture canopy, and then

secure the rod assembly to the coupling kit of the fixture canopy.

5. Pull out the source wires from the outlet box. Make wire

connections using wire connectors as follows:

---Connect the smooth-coated wire (marked) from the

fixture to the black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the

fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting

plate with the green grounding screw, and then

connect it to the house grounding wire with a wire connector.

Carefully put the wires back into the outlet box.

6.Put the glass into the trapezoidal frame, always keep the smooth

side of the glass face out, press the small iron shim in the frame onto the glass and make sure it is tight.

7. Install the bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Screw (C)

Lock Nut (F)

Wire Connector (E)

Mounting Plate (A)

Fixture Mounting

Screw (D)

Green Grounding

Screw (B)

Ball Nut(G)

Fixture

Threaded Pipe

Bulb Type A

Max.60W

(not included)

Socket

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
8. Attach the fixture canopy to the mounting plate by inserting the fixture mounting screws, and then secure it with two ball nuts. Fig. 1 Support Brace 9. Angled mounting recommended for a vaulted or angled ceiling. (See Fig. 1) Outlet Box Turn on the power at fuse or circuit box. Canopy Coupling Kit The following parts are available for re-order if damaged or missing.