Owner Manual

ManualsBrandsWrought Studio Manuals5 Piece Kitchen & Dining Room SetsBeveridge 4 - Person Counter Height Dining Set

ASSEMBLY RATING







 





O O O





Tools Required For Assembly:







(Included) 





(Not Included)

2 PERSONS RECOMMENDED

Page 1 of 6

Assembly Instructions

Summary of content (6 pages)

PAGE 1
Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
PAGE 2
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES 1 When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
PAGE 3
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. / '- / q / ' Parts List #1x 2pcs Table Leg '- ,) / #2x 2pcs Table Leg Support / #3 X 1pc '- ' #4 X 1pc '/ \ ' #Bx 6pcs Bolt 1/4" x 3" ,I R #5x 8pcs Chair Leg ' #6x 8pcs Chair Support Leg #7x 4pcs '- ' / � ,I / � ' Chair Bottom Support Leg #8x 4pcs Screw M5X1- 5/8" '- / '- #D x 16pcs <\\\\\'@ Table Top � '- #Ax 72pcs Bolt 1/4" x
PAGE 4
#.8 #1 #1- Align table leg supports (#2) and table leg bottom support (#3) to the holes of the table legs (#1). Secure by using bolts (#A). I #Ax 24pcsi #2 \ #1 #1 Page 4 of 6
PAGE 5
Prepare 6 bolts assembly by inserting washer (#C) onto bolts (#B). Align table base to the table top (#4), then secure by using bolts (#B). #8 x 6pcs #C x 6pcs -----#4 I #Ax 48pcsi Align chair support (#6) and chair bottom support (#7) to the holes fo the chair legs (#5). Secure by using bolts (#A).
PAGE 6
I #D x 16pcs I Align chair legs to the seat panel (#8), then secure by using screws (#D). There are no pre-drilled holes.