Installation Sheet
Wall-mount Sinks Installaon Instrucons
.
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
W a l l - m o u n t S i n k s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. 215 513 9400 - Fax 610 831 0215
www.wsbathcollections.com - info@wsbathcollections.com
Page 1/3
Before You Start Installaon
We recommend that you consult with a profession-
al if you are unfamiliar with installing this type of
product. WS Bath Collecons accepts no liability for
any damage to the property; oor, walls, pluming,
sink, or personal injury during installaon.
Follow up all local plumbing and building codes.
Geng Started
Insure that you have all the requires materials and
tools for the installaon.
Install sucient backing behind the nished wall to
provide adequate support to secure the mounng
hardware (refer to diagram aached). If the studs
do not align with the sink, proper wood blocking
must be installed between the studs where the sink
will mount.
Make sure that in-wall plumbing has already been
prepared.
Unpack the new sink and inspect it for damage prior
to installaon.
Installaon
1. Hold the sink up at the desired installaon loca-
on. Ensure that the sink is level, then mark the
locaon of the mounng holes on the back of
the sink.
2. Drill pilot holes at the marked locaons of the
sink’s mounng holes.
3. Insert the anchors into the drilled holes, screw
in the mounng hanger bolts.
4. Move the sink back into posion at the installa-
on locaon.
5. Secure sink with washers and nuts. Be careful
not to over ghten the bolts to avoid sink chips
and cracks.
6. Proceed to installaon of the drain, trap, water
supply lines, and the sink faucet.
7. Complete the installaon by applying a thin
bead of silicone around the back of the sink
where it meets the wall.
Tools You May Need
Measuring Tape Level Pencil
Stud Finder Drill Silicone Sealant
100%
Bolt Drywall Anchor Wrench
Note
WS Bath Collecons reserves the right to make revisions in the design of prod-
ucts without noce.