Installation Guide
.
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
S i n k s D r a i n s &
T r a p s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. 215 513 9400 - Fax 610 831 0215
www.wsbathcollections.com - info@wsbathcollections.com
Before You Start Installaon
We recommend that you consult with a profes-
sional if you are unfamiliar with installing this
type of product. WS Bath Collecons accepts
no liability for any damage to the property;
oor, walls, pluming, sink, or personal injury
during installaon.
Follow up all local plumbing and building
codes.
Geng Started
Insure that you have all the requires materials
and tools for the installaon.
Installaon
1. Insert the drain as shown in picture, ght-
en the drain nut from underneath of the
sink. Make sure not to over ghten to
avoid sinks chips and cracks.
2. Insert trap horizontal pipe to waste open-
ing to wall.
3. Aach vercal pipe/ trap to drain tail
piece and hand ghten together.
4. Align vercal pipe/ trap with trap horizon-
tal pipe. Cut part of the horizontal pipe as
necessary to obtain the proper alignment.
5. Tighten trap horizontal pipe to wall. Tight-
en waste cover
6. Check for leakage by opening faucet and
leng water run for at least 45 seconds.
Sinks Drains & Traps installaon instrucons
Page 1/1
1.1 Insert drain
5. Tighten trap horizontal pipe
to wall. Tighten waste cover
2. Insert trap horizontal pipe
1.2 Tighten drain nut
3. Aach vercal pipe/ trap
to drain tail piece