Installation Guide

.
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
S i n k s D r a i n s &
T r a p s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. [phone] - Fax [phone]
www.wsbathcollections.com - [e-mail]
Before You Start Installaon
We recommend that you consult with a profes-
sional if you are unfamiliar with installing this
type of product. WS Bath Collecons accepts
no liability for any damage to the property;
oor, walls, pluming, sink, or personal injury
during installaon.
Follow up all local plumbing and building
codes.
Geng Started
Insure that you have all the requires materials
and tools for the installaon.
Installaon
1. Insert the drain as shown in picture, ght-
en the drain nut from underneath of the
sink. Make sure not to over ghten to
avoid sinks chips and cracks.
2. Insert trap horizontal pipe to waste open-
ing to wall.
3. Aach vercal pipe/ trap to drain tail
piece and hand ghten together.
4. Align vercal pipe/ trap with trap horizon-
tal pipe. Cut part of the horizontal pipe as
necessary to obtain the proper alignment.
5. Tighten trap horizontal pipe to wall. Tight-
en waste cover
6. Check for leakage by opening faucet and
leng water run for at least 45 seconds.
Sinks Drains & Traps installaon instrucons
Page 1/1
1.1 Insert drain
5. Tighten trap horizontal pipe
to wall. Tighten waste cover
2. Insert trap horizontal pipe
1.2 Tighten drain nut
3. Aach vercal pipe/ trap
to drain tail piece