User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Buttons
- Main Screens
- Site Configuration Tools
- Two-Way Paging
- Configuration Methods
- MENU Configuration
- Serial Command Configuration
- Protocols
- SCADA Support
- IO Mirror Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- WTE Ack and Confirm Protocol
- Store Forward Operation
- Installation
- Input Output Hardware Connection
- Serial Connections
- RF Connections
- Power Connections
- Ethernet Interface
- TReX Firmware Upgrade
- Physical Dimensions
- Mounting Hardware
- Omni or Directional Antenna
- Antenna Elevation
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Abbreviations and Glossary
- Specifications
TReX User Manual v2.14 Firmware
Example 2:
Message payload to have delivery acknowledged and confirmed is transmitted.
All units, go to Pukeko Place urgently.-[347-2-Turnout Y/N?]<CR>
The remote TReX unit immediately displays:
Remote TReX immediately responds with:
ACK[347]
If message has been accepted (by pressing the square “ENTER/ACCEPT” button) remote
TReX responds with:
ACC[347-Unit 41]
Note that the “Unit 41”in the confirmation response is the TReX programmed unit ID.
Example 3:
Message is transmitted from base station using WT Protocol together with the Acknowledge
and Confirm Protocol added to the end to the message.
WT1234567A10 HEART ATTACK, 45 YO MALE, 12 PUKEKO PL.-[**01-3-ATTEND?]<CR>
Note: The WT Protocol must be used to automatically expand the **01 macro to an
automatically incremented ticket id.
The remote TReX unit immediately displays:
In this case, the received message has not requested delivery confirmation, only confirmation
© WTE Limited, 2018 – Christchurch New Zealand Page 118 of 158