User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Buttons
- Main Screens
- Site Configuration Tools
- Two-Way Paging
- Configuration Methods
- MENU Configuration
- Serial Command Configuration
- Protocols
- SCADA Support
- IO Mirror Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- WTE Ack and Confirm Protocol
- Store Forward Operation
- Installation
- Input Output Hardware Connection
- Serial Connections
- RF Connections
- Power Connections
- Ethernet Interface
- TReX Firmware Upgrade
- Physical Dimensions
- Mounting Hardware
- Omni or Directional Antenna
- Antenna Elevation
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Abbreviations and Glossary
- Specifications
TReX User Manual v2.14 Firmware
Ethernet Interface
The TReX supports a 10/100 Base-T Ethernet connection.
To simplify network setup, the TReX supports auto-negotiation and auto-sensing MDI/MDIX
crossover.
General Interface RJ45
Cabling CAT-5/6 UTP, supports auto
MDIX (Standard Ethernet)
Bandwidth allocation The Ethernet capacity
maximum is determined by
the
available radio link capacity.
Ethernet mode 10Base-T or 100Base-TX
Full duplex or half duplex
(Auto-negotiating and auto-
sensing)
Diagnostics Green LED Off: No data present on the
interface.
On: Data present on the
interface.
Orange LED Off: no Ethernet connection
On: Ethernet signal received
© WTE Limited, 2018 – Christchurch New Zealand Page 136 of 158