User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Buttons
- Main Screens
- Site Configuration Tools
- Two-Way Paging
- Configuration Methods
- MENU Configuration
- Serial Command Configuration
- Protocols
- SCADA Support
- IO Mirror Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- WTE Ack and Confirm Protocol
- Store Forward Operation
- Installation
- Input Output Hardware Connection
- Serial Connections
- RF Connections
- Power Connections
- Ethernet Interface
- TReX Firmware Upgrade
- Physical Dimensions
- Mounting Hardware
- Omni or Directional Antenna
- Antenna Elevation
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Abbreviations and Glossary
- Specifications
TReX User Manual v2.14 Firmware
Mount Bolts Dimensions
Both top and bottom are symmetric as are the left and right sides of the TReX radio, this
allows a wide range of mounting configurations.
The channels space from centre to centre in the top and bottom of the radio is 117.40mm
Dimension are in millimetres
© WTE Limited, 2018 – Christchurch New Zealand Page 144 of 158