User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Buttons
- Main Screens
- Site Configuration Tools
- Two-Way Paging
- Configuration Methods
- MENU Configuration
- Serial Command Configuration
- Protocols
- SCADA Support
- IO Mirror Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- WTE Ack and Confirm Protocol
- Store Forward Operation
- Installation
- Input Output Hardware Connection
- Serial Connections
- RF Connections
- Power Connections
- Ethernet Interface
- TReX Firmware Upgrade
- Physical Dimensions
- Mounting Hardware
- Omni or Directional Antenna
- Antenna Elevation
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Abbreviations and Glossary
- Specifications
TReX User Manual v2.14 Firmware
RX Screens
Screens that relate to messages received. Note, when messages are received, additional icons
may be displayed in the top bar.
The second left icon changes from the “X” icon to the satellite icon when a message has been
received. This indicates that the receiver is operational.
When the “BELL” icon is displayed with a following number, this means that system ALERTS
are enabled. See ALERTS for ALERT configuration and operation.
RX (1):
Basic summary of last received message. If the message is too large to fit on the screen the
DOWN arrow will be visible in the title bar. Pressing the DOWN button will now scroll
through the rest of the message.
RX (2):
List of all time-stamped received messages retrieved from internal storage. Most recent
message displayed at top. Next sub-screen can only be selected when top entry is displayed.
Note that messages are only available here when RX logging has been enabled (MENU->RX-
>MSG LOG).
Messages starting with “*” are messages that met the ALERT filter requirements, and were
eligible to operate the ALERT output when logged.
© WTE Limited, 2018 – Christchurch New Zealand Page 19 of 158