User's Manual

ManualsBrandsWTE TReX UHF ManualsElectronicsUHF Digital Transceiver

Table Of Contents

Introduction
- TReX Features
- TReX Versions
Safety Information
Operation
Buttons
- MENU/BACK:
- UP:
- DOWN:
- RIGHT:
- ENTER:
Main Screens
- IO Screens
- TX Screens
- RX Screens
Site Configuration Tools
- Spectrum Analyser
- Demodulated Signal Viewer
Two-Way Paging
Configuration Methods
- Front Panel Menu Configuration
- Web Browser Configuration
- Serial Command Configuration
MENU Configuration
- SYSTEM Menu
- TEST Sub Menu
- FACTORY Sub Menu
- TIME Sub Menu
- SPECTRUM Menu
- RX Menu
  - FILTERS
- Protocol Menu
- TCP-IP Menu
- Telemetry Menu
- SERIAL LINK Menu
- STORE FWD Menu
- Inputs Menu
- ADC CAL Sub-Menu
  - Input Config Sub-Menu
- Outputs Menu
  - Output Config Sub-Menu
  - DAC CAL Sub-Menu
Serial Command Configuration
- Main Commands
- Transmit Commands
- Receive Commands
- Store Forward Commands
  - *STORE_FWD
- Input Commands
- Output Commands
  - *OUT_CONFIG
  - *UNIT_ID
- System Commands
- TCP-IP Commands
Protocols
- WT Protocol
  - Variable Content Macros
- Modbus
- Custom Protocol
  - Custom Protocol Response
  - Custom Protocol Output
- RAW Protocol
SCADA Support
- Terminology
- SCADA System Single TReX Configuration
  - Unit Configuration
- SCADA System Multiple TReX Configuration
  - Units Configuration
- Viewing Multiple TReX Unit IO on the MASTER Unit.
- SCADA Communication Between MASTER and SLAVE
IO Mirror Operation
Input Handling
Output Handling
WTE Output Control Protocol
- Introduction
- Digital Output Format
  - Examples:
- Analog & Digital Output Format
WTE Ack and Confirm Protocol
- Introduction
Store Forward Operation
Installation
- Cables Supplied
- Connecting to the TReX
- Connector Pin descriptions
  - RHS (Right Panel)
  - LHS (Left Panel)
Input Output Hardware Connection
- Inputs
- Outputs
Serial Connections
- RS-232
- RS-422/RS-485
RF Connections
Power Connections
Ethernet Interface
TReX Firmware Upgrade
- Firmware Upgrade Utility
- Upgrade Process
Physical Dimensions
Mounting Hardware
- DIN Rail
- Mounting Channels
- TOP Mount
- SIDE Mount
- Bottom Mount
- Mount Bolts Dimensions
- Top and Bottom Drilling Template
- Side Drilling Template
Omni or Directional Antenna
- Omni antenna
- Directional antenna
Antenna Elevation
Disclaimer
Manufacturing marking and labels
Maintenance
Product End Of Life
Product Warranty
Abbreviations and Glossary
Specifications

TReX User Manual v2.14 Firmware

restart the unit after changing configuration. This can be achieved by removing power to the

unit or sending the *REBOOT<CR> command.